Skip to main contentdfsdf

Home/ tonercartridge1's Library/ Notes/ Steps on Reconditioning Your Toner Cartridge

Steps on Reconditioning Your Toner Cartridge

from web site

Image 1

It is required for you to have a laser toner refill kit for your specific model of your cartridge, since the toner amounts and needed accessories vary from one of the cartridges to the next. Most of cartridges require a chip that will be replaced before your laser printer recognizes the refilled cartridge as being full. When one of them is needed, it may be included with the kit.

So, you do not need to think twice. It is necessary for you to have these refill kits. If you want to purchase these refill kits, you can find them at any retail cartridge stores. Get them now and you will see how they will give you more advantages. To help you more, here is information for you.

For the first step, you should open the front of your laser printer by pulling the front of panel open. If you cherished this posting and you would like to get much more data about hp toner kindly take a look at the website. Then, locate your toner cartridge, and release the handle that will hold it in the place. It will normally consist of the two plastic tabs that are located on either side of your cartridge. After that, remove it by pulling directly, and lay it on the flat work surface.

For the second step, you can consult the documentation that will give the refill kit for the refill locations. Most of cartridges normally have the removable plug or cap that is specially designed for the refills. If there is no location for the existing fill, the kit will come with the hand-drill. You can place it in he marked location in the instructions, and then turn it clockwise until the hole has been bored trough a surface.

For the next step, you have to remove the cap from your toner refill bottle, and then pour the contents trough a refill hole. When it is done, you can discard the bottle. Replace the cap. If the hole was drilled, you need to use one of the hole sealing stickers that are included in your refill kit, or the regular piece of the clear tape in order to keep your toner from spilling out.

For the last step, you have to slide the chip of the cartridge out of the socket by using the small pair of tweezers. Then, slide the replacement back in the similar way with the old one came out. If your refill kit did not come with one of the chips, then the replacement will not be necessary. After that, insert your cartridge back into your printer, and then print as normal.

tonercartridge1

Saved by tonercartridge1

on May 12, 18