Some Known Questions About 7 authentic vintage countertop laminate designs still available.

Cut these strips with the keep piece off the lumber. Task the cutline inch past the edge (to represent the router bit's width). When using a router, cut from delegated right as you face the edge (and the tool is upright), to keep the bit from pulling. Adhere the side pieces Using a chip brush, use contact cement to the back of the laminate strips for the counter's short sides and onto the substrate sides.

Allow the contact cement on both parts to dry to the touch. Take a strip and position it over the side without letting it touch, making sure it's equally aligned all around. Working from one end to the other, stick the laminate to the substrate, smoothing it as you go.

Retouch unequal edges Utilizing the router turned on its side, cut off the overhanging edges of laminate, running the bit counterclockwise around the edges. Retouch uneven edges with a file or sander, keeping it flat on top of the particleboard and pressing far from the laminate. With the sides done, glue and cut the front edge.

Dimensions Laminate Countertop - VT Industries

Keep the bit totally free of adhesive by periodically disconnecting the router and soaking the bit in water. Cover laminate back and substrate with contact cement Turn the top laminate sheet facedown. Put contact cement onto the back and, using a paint roller, spread the adhesive over the whole sheet. Roll any excess onto the substrate.

The Buzz on How to fasten laminate countertops to cabinets- Mal-O-Sen

Enable the contact cement to dry to the touch on both parts. Laminate the top Lay wood scraps or dowels across the substrate every 12 inches approximately. Turn the laminate so that it is adhesive-side down, and rest the sheet on top of the scraps without allowing it to touch the substrate.

Formica Countertops

Surprise, Laminate Countertops Are Cool Again - Real Simple

Starting in the middle, get rid of a scrap and press the laminate down. Official Info Here from the center, continue getting rid of scraps and pushing the sheet into location, up until the entire sheet is adhered. Roll over the counter with the J-roller, using company strokes. Utilizing the trim router, cut off the excess around the border.