from web site
As soon as all the pieces are taped in place, mark all the joints in between strips with reference lines that encounter the seam of the adjoining pieces. Utilizing a hot glue gun, carefully secure each intersection, making sure to realign the recommendation marks. When the glue is dry, untape the design template, then thoroughly fold it up and send it to the maker with your butcher-block order.
Also send along makers' item specification sheets (offered online). 5. Prepare the Cabinets If you're working with open-topped cabinets, you'll need to install blocking so there's something to screw the butcher block to. Using a handsaw, cut plywood or 1x scrap to fit securely within the width of the cabinet.
Fit the blocking in place at the front of the cabinet. Secure it to the cabinet with 1-inch deck screws through the pilot holes. If your cabinets have solid tops, it's best to glue down furring strips in order to create an air space below the countertop and avoid it from cupping in circumstances where humidity swings are a concern.
Lay these strips every 16 inches throughout the cabinet tops, sticking each down with a bead of kitchen area and bath sealant. To make This Is Cool in the blocking, initially drill a little starter hole directly down, then pull the bit out and rearrange it at an angle in the hole.
Connect the Butcher Block Utilizing a drill/driver fitted with a -inch paddle bit, drill through the center of the stopping or through the strong cabinet top at one furring strip. Develop one hole like this on each cabinet. When making the holes in the cabinets, keep the bit from burning out the wood around the hole by securing a scrap block of wood against the cabinet top.
Tighten up Down the Block From inside the cabinet, drive a deck screw fitted with a fender washer up through each hole, into the butcher block. (Ensure the screw is shorter than the counter is thick.) Tighten the screw till it simply pulls the block snug to the cabinet. These screw "clamps" will allow the counter top to slightly move and prevent the butcher block from separating, cracking or splitting as the wood broadens with humidity.