from web site
Usually, you'll desire your family pet's door to be a minimum of 3 inches from the flooring at a minimum, and centered in the middle of the door. Your particular door will have a suggestion for where the shoulder height need to be in relation to the bottom of the door. Following your door's directions, use a pencil and a straight edge to set out all of the cut lines on the door.
When you start cutting any door, there's no turning back. So, make certain you're precise and take your time. Center Punch and Drill Holes in the Corners Usage Center Punch to Mark Hole Starts Using your automated center punch, press firmly in each corner to produce a small damage about 1/4" inward from the standard.
As soon as you've put a damage in each corner, place the point of your drill in a damage and start to gradually drill. You want to go directly down and all the way through the door, putting one hole in each corner. Tape Off the Border and Saw Glide Tape off Perimiter of the Openng Tape off the Bottom of the Jigsaw After you've drilled your corner holes, it's a good idea to protect the door prior to cutting.
This will safeguard against scratching the surface area of your door. Use two layers if your door's surface appears more susceptible to scratching. Pick the Right Blade and Cut Your Opening Metal cutting blades are considerably various from those used to cut wood. They have more teeth, that are smaller and closer together, similar to a hacksaw.
Select a metal cutting blade enough time to cut through both sides of the door at the same time. Insert Learn More Here into one of the corner holes you drilled, and cut along the outside of the line toward the next hole. The holes give you enough room at each corner to turn the saw and make your next cut.
Test Fit Frame Mark Screw Holes You'll wish to test fit the frame for your pet door to guarantee that it fits from both sides of the door. It's an excellent concept to check the fit with the cover and any other accessories attached. Then, utilizing a pencil, mark the holes in the frame for the fasteners.