How Do Dirt Bike Graphics Be Put In Place?

Substance Incorporated has been our long-term partner in dirt bike graphics. Substance Incorporated, a market leader in the production of motocross graphics for screen printing and digital printing is a company that has an unmatched passion and imagination. Visit https://www.facebook.com/decallaboratory/ website for effective information on dirt bike graphics now.

Earlier you start
Check your plastics to see if they are scuffed and damaged or scratched, it's worth replacing the parts. Before you can install dirt bike graphics kits the plastics of the dirt bike need to be in excellent condition.

You will need the following to put dirt bike graphics on your vehicle:
adhesive tape for paper;
paper knife / scissors;
The hair dryer or the heat gun
alcohol-water or degreasing agents;
squeegee (optional);

Cleanse your hands. While preparing surfaces or working on graphics, it's essential to clean your hands. Hands that are dirty or oily will limit the ability of the dirt bike's graphics to adhere.

Preparing surface
Before you can begin installing dirt bike graphics, it's essential to get rid of old decals. Hair dryers or a heated gun can be used to warm up old graphics so that they're easy to get rid of. Cleanse the surface using a degreasing agent. It is essential not to leave any glue residues left by old graphics, oil or dirt. Before applying motocross graphics to dirt bikes, the plastics need to first be warmed up. Plastics should be kept in a location with temperatures of more than 15°C/60°F for a few hours.

Applying graphics
Put your logo on the plastic. Number plate Adhere the decal onto the plastic using adhesive tape. This will hold your decal in the correct location. You can apply the amount of tape that you would like to use. Cut the backing paper off the background. Make sure you are aligned with the area you intend to be covering. To place the graphic at the correct location you need to touch the other side by using your fingers.

You can work in sections by using your thumb or squeezer to apply pressure on the graphics. Be careful not to create wrinkles or bubbles. Start by beginning at the middle. You can remove any bubbles by gently peeling the section off and then trying again. To pop tiny air bubbles, use the safety pin. Next, smoothen the bubble by moving toward the edges. The process can be repeated on the other side of the decal.

You can melt graphic designs with sharp edges by using the help of a heat gun to make them more elastic. Be cautious not to burn yourself!

If required, cut off excess sections or sections of graphics that cover bolts or access holes or vent slits. Use a paper knife.

Installation tips
Be patient and take your time! It's not as hard as you might think.
Make sure to keep your dirt bikes or plastics in place for a few hours prior to installation. Don't allow them to remain in temperatures greater than 15°C/60°F.
to ensure that bonding is secure for the proper amount of bonding time before riding.