What Do You Remember Before Boiler Cleaning And Maintenance?

Boiler cleaning and maintenance is among the most effective processes that must be routinely performed on Marine boilers installed on ships. Regular cleaning is necessary for the prevention and removal of particle and carbon deposits from boilers.

However while doing boiler cleaning and boiler maintenance in Guangzhou there are a few important points to remember:

Proper treatment of boiler water is important

If water inside boiler is treated in a proper way with chemicals, and the chemical concentration is in an acceptable range, the deposits on the water walls and boilers' steam side will be minimal.

In case the boiler is working on fresh water instead of heavy water, there will be minimal deposits within the tubes - which can be removed by boiling water out. Hard deposits within tubes can be removed from the upper drum with the aid of brush and scrubber.

Water washing and soda solution can be useful

In case the boiler oil burner is properly functioning and effective maintenance is conducted regularly, then there will be minimal amount of soot deposits within the oil fired boiler. However, it is impossible to avoid soot deposits completely - given that during the initial phase there is more amount of boiler soot deposition and it gathers within the boiler space over time.

It is possible to get rid of the soot deposits with the aid of water washing, along with 10% soda solution - via the inlet door in the uptake.

A water hose marine equipment in China should be used for the process

Take important precautions during water washing

While washing your boiler with water, it is important for you to take all the necessary precautions. It must be ensured that the refractory within the boiler never gets wet. Use a plastic sheet to cover the refractory during water washing. The water must be continuously drained off via the drain at the bottom.

If the refractory becomes weight you should light up the boiler very gradually. If that is not done, the refractory will get cracked and drop off, finally leading to overheating. There will be deformation within the boiler as a result.